Fieldserver LonWorks FS-8700-21 Manual do Utilizador descarregar pdf (Página 35)

FS-8700-21 LonWorks Manual Page 35 of 72

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com

Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]

Appendix B.2. Checking LONWORKS® Network Using Echelon’s NodeUtility.exe

Run Nodeutil.exe.

Press Service Pin on all LONWORKS® Devices.

Press ‘F’ to find Nodes.

Press ‘L’ to List Nodes, Confirm that all Nodes can be seen.

Press ‘G’ (Goto) each Node and:

o Dump Node Domain Table ( ‘D’, Enter ).

o Confirm Domain ID is correct ( usually , “F” ).

o Record Node.

o Confirm that Subnet is “1”.

o Confirm that Size is “1”.

Press ‘L’ (List) Network Variables.

o Record SNVT Type and Index.

Appendix B.3. Neuron Systems

Newron Systems may produce the following Error message “bindings lost after power-cycle” The solution to this is

to place the FieldServer in the Configured state which will cause the bindings to be committed to the Neuron and

they will remain after a power cycle.

Procedure:

1) Make the bindings in NL220

2) Place devices in ONLINE mode or state.

3) Refer to the following Screencap for assistance in placing the FieldServer in the Configured state.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 71 72

Sem comentários

Fieldserver LonWorks FS-8700-21 Manual do Utilizador Página 35