
FS-8700-16 BACnet PTP Serial Driver Manual Page 7 of 32
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll Free: (888) 509-1970 email: support@fieldserver.com
4 CONFIGURING THE FIELDSERVER AS A BACNET CLIENT
For a detailed discussion on FieldServer configuration, please refer to the FieldServer Instruction Manual. The
information that follows describes how to expand upon the factory defaults provided in the configuration files
included with the FieldServer (See “.csv” sample files provided with the FieldServer).
This section documents and describes the parameters necessary for configuring the FieldServer to communicate
with a BACnet PTP Server.
The configuration file tells the FieldServer about its interfaces, and the routing of data required. In order to enable
the FieldServer for BACnet communications, the driver independent FieldServer buffers need to be declared in the
“Data Arrays” section, the destination device addresses need to be declared in the “Client Side Nodes” section, and
the data required from the Servers needs to be mapped in the “Client Side Map Descriptors” section. Details on
how to do this can be found below.
4.1 Data Arrays/ Descriptors
Note that in the tables, * indicates an optional parameter, with the bold legal value being the default.
Provide name for Data Array
Up to 15 alphanumeric characters
Provide data format. Each Data Array can only
take on one format.
Float, Bit, Uint16, Uint32, Sint16,
Sint32, Packed_Bit, Byte,
Packed_Byte, Swapped_Byte
Number of Data Objects. Must be larger than the
data storage area required by the Map
Descriptors for data placed in this array.
Example
Comentários a estes Manuais